Hitachi Compute Blade 500 Series - Page 84

Item Description
System settings Logical partitioning Displays operation mode of the server blade.
IP address Displays the LP IP address.
Subnet mask Displays the subnet mask.
Default gateway Displays the default gateway.
LP ID Displays the LP ID.
VNIC system No. Displays the VNIC system number.
Date and
time
Time
zone
Displays the time zone.
Sync
NTP
1
Displays the server with which the time is
synchronized.
NTP: The time is synchronized with the NTP
server.
SVP: The time is synchronized with the
management module.
OFF: The time is not synchronized.
NTP
import
1
Displays the server from which the NTP setting
is imported.
SVP: The NTP setting of the management
module has been imported.
BMC: The NTP setting of BMC has been
imported.
NONE: The NTP setting is not imported.
NTP
server1,
NTP
server2
1
Displays the IP address of the NTP server with
which the time is synchronized.
Note that this setting is valid only if "NTP" is
set for "NTP synchronization".
LP CLI
Authentication
1
Displays the user authentication setting for LP
CLI.
Enable: User authentication is required when
connecting by using the HvmSh command.
Disable: User authentication is not required
when connecting by using the HvmSh
command.
CLI IP address 1-8 Displays details of the CLI IP address settings.
Virtual COM
console port
Connection mode
1
Displays virtual COM connection mode (Telnet
or SSH).
Telnet
authentication
1
Displays the user authentication settings for a
Telnet connection.
Enable: User authentication is required when
connecting via Telnet.
Disable: User authentication is not required
when connecting via Telnet.
Note that user authentication is required when
connecting by using SSH.
2-74
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide