Hitachi Compute Blade 500 Series - Page 114

USB Configuration
In USB Configuration, you can change the USB settings.
Menu items
Selection
1
Description
Front Dongle USB Port #1 Disable
<<Enable>>
Enables or disables USB ports.
Front Dongle USB Port #2 Disable
<<Enable>>
Enables or disables USB ports.
Front USB3.0 Port Disable
<<Enable>>
Enables or disables USB ports.
Note:
1. A value in double angle brackets, << >>, shows the default.
Memory sub menu
Select the item to display or set, and press Enter.
The following table shows description of menu items displayed in the left side
of the window.
Table 2-83 Memory menu items
Menu items
Selection
1
Description
System Memory Details - Displays the status of each system
memory.
See System Memory Details on
page 2-95.
Total Memory Size - Displays the total memory size.
Memory Voltage - Displays the memory operating
voltage.
Memory Mode • Lockstep
• <<Independent>>
Selects a memory operating mode.
Memory Speed •
<<Auto>>
• Force DDR3 1066
• Force DDR3 1333
• Force DDR3 1600
Sets a maximum value on memory
clock frequency.
DDR Voltage Level • Auto
• <<Force to 1.50V>>
Sets the memory operating
voltage.
Memory Power
Management
2
•
Disable
• <<Automatic>>
Sets Memory Power Management.
Socket Interleave
• Non-NUMA
• <<NUMA>>
Sets Memory Socket Interleave.
2-94
UEFI setup menu
Hitachi Compute Blade 500 Series EFI User's Guide