Hitachi Compute Blade 500 Series - Page 120

Table 2-86 RAS Configuration menu items
Menu items
Selection
1
Description
Machine Check Recovery • Disable
• <<Enable>>
Enable or Disable Machine Check
Recovery.
PCI Live Error Recovery
• <<Disable>>
• Enable
Enable or Disable PCI Live Error
Recovery.
PCIe Isolation
2
• <<Disable>>
• Enable
Enable or Disable PCIe Isolation.
Hardware Memory Dump
2
• <<Disable>>
• Enable
Enable or Disable Hardware Memory
Dump.
Dump Partition
2
No Present Shows Dump Partition.
Post Process
2
• <<Spinloop>>
• Reset
Sets Post Process.
Deconfigured Mode
• <<Disable>>
• Enable
Enable or Disable DIMM Deconfigured
Mode. Shown with the server blade
firmware version 06-10 or later.
POST Fail Retry • Disable
• <<Enable>>
Enable or Disable POST Fail Retry. POST
Retry is performed automatically when
EFI firmware detects any memory failure
at POST.
Notes:
1. A value in double angle brackets, << >>, shows the default.
2. These items are displayed but are not available.
Security sub menu
Place the cursor on a menu to set, and press Enter.
The following table shows description of menu items displayed in the left side
of the window.
Select a menu to set, and press Enter.
Table 2-87 Security sub menu items
Menu items Selection Description
Secure Boot Configuration - Sets the secure boot configuration.
Trusted Platform Module
(TPM 1.2)
- Displays TPM option setting window. See
Trusted Platform Module (TPM 1.2) on page
2-100 for details.
Trusted Platform Module (TPM 1.2)
Place the cursor on an item to set, and press Enter.
2-100
UEFI setup menu
Hitachi Compute Blade 500 Series EFI User's Guide