Hitachi Compute Blade 500 Series - Page 132

Menu items Description
Processor Details Displays details of the installed processors.
Memory
Memory Mode Displays the memory mode.
Memory Speed Displays the installed memory speed.
Total Memory Size Displays the total installed memory size.
Memory Voltage Displays the memory operating voltage.
System Settings
Select an item to display or set, and press Enter.
Note: Do not change the settings of the following items. If you change the
settings, UEFI may not start up.
• Adapters and UEFI Drivers
• Devices and I/O Ports
• Legacy Support
• Network
• Storage
For Emulex 8 Gb FC mezzanine card or Emulex CNA mezzanine card
(Personality: FCoE/iSCSI), however, see the Hitachi Compute Blade Emulex
Adapter User's Guide for Hardware to set the following two items.
– Network
– Storage
For Hitachi Gigabit fibre channel adapter, however, see the Hitachi Gigabit
Fibre Channel Adapter USER'S GUIDE (BIOS/EFI Edition) to set the following
two items.
– Adapters and UEFI Drivers
– Storage
The following table shows description of menu items displayed in the left side
of the window.
Table 2-100 System Settings menu items
Menu items Description
Adaptors and UEFI Drivers Displays information about adapters and UEFI drivers on the
server blade.
Devices and I/O Ports Displays devices and I/O port options of settings.
Driver Health Displays the driver status.
Legacy Support Displays the legacy support setting window.
Memory Displays and provides option to change the memory settings.
See Memory sub menu on page 2-114.
2-112
UEFI setup menu
Hitachi Compute Blade 500 Series EFI User's Guide