Hitachi Compute Blade 500 Series - Page 163

Menu items Description Setting/display value
Alarm Control Sounding the buzzer on the
controller in the event of failure
at a connected device
[<<Disabled (not
sounding)>>]
Patrol Read Rate
3
Priority of patrol reading 0 to 100 / [<<30>>]
Cache Flush Interval
3
Flush timing for write-cache data 1 to 255 / [<<4>>]
Spinup Drive Count
4
Number of disk motors to start
at system startup
0, <<1>> to 8 / [2]
Spinup Delay
3
Timing for disk motors to start at
system startup
0 to xxx / [<<6>>]
Notes:
1. This can be changed only when no disk arrays have been set at all.
2. Do not use "Set Factory Defaults." This setting must be changed to the
recommended values.
3. Always use the "Default" setting.
4. Always use the recommended values.
Tip: Place the mouse cursor on a setting item and left-click the mouse to
change the setting values. Or, left-click the mouse to move the cursor and
enter a value from the keyboard. Click Submit after the setting.
Controller properties submenu 2
Click Next in the Properties: Controller properties submenu 1 window.
The following window is displayed.
Note: Do not set the value of items Stop CC On Error, Schedule CC,
Maintain PD Fail History, Disk Activity, and Manage Powersave.
They are not supported.
MegaRAID WebBIOS for LSI SAS 2008
3-13
Hitachi Compute Blade 500 Series EFI User's Guide