Hitachi Compute Blade 500 Series - Page 316

For an SMP configuration connected to a 2-blade SMP connect board:
- The RAID controller of the primary server blade: "Bus" is identified
with a number from 0 to 127.
- The RAID controller of a non-primary server blade: "Bus" is
identified with a number from 128 to 255.
For an SMP configuration connected to a 4-blade SMP connect board:
- The RAID controller of the primary server blade: "Bus" is identified
with a number from 0 to 63.
-The RAID controller of the second non-primary server blade from the
bottom: "Bus" is identified with a number from 64 to 127.
- The RAID controller of the third non-primary server blade from the
bottom: "Bus" is identified with a number from 128 to 191.
- The RAID controller of the fourth non-primary server blade from the
bottom: "Bus" is identified with a number from 192 to 255.
7. The utility starts up.
5-8
SAS 3004 iMR ROMB Configuration Utility
Hitachi Compute Blade 500 Series EFI User's Guide