Hitachi Compute Blade 500 Series - Page 338

Virtual drives have been successfully created.
Then, initialize virtual drives referring to Initializing virtual drives on page
5-34.
Adding virtual drives
You can add virtual drives following the steps below.
1. Select Create Virtual Drive - Advanced
on the Configuration
Management window, and press Enter
.
Note: Do not select Create Virtual Drive on the Configuration
Management window. If Create Virtual Drive is selected, you cannot
create virtual drives with correct setting values.
2. Create Virtual Drive - Advanced window appears.
3. Select Select Drives From and press Enter.
4. Select Free Capacity and press Enter.
5. Select Select Drive Groups and press Enter.
6. Select Drive Groups window appears.
7. Select a Drive Group to add virtual drives to and press Space.
5-30
SAS 3004 iMR ROMB Configuration Utility
Hitachi Compute Blade 500 Series EFI User's Guide