Hitachi Compute Blade 500 Series - Starting the utility

Table 6-1 Key operation
Key Operation
[↑], [↓], [←], [→] Moves the cursor.
[Enter], [Space] Selects an item that the cursor is placed on.
Determines an item setting.
Changes values.
[+], [-] Changes a numeric value.
[Esc] Exit the current menu.
Note: You can use only the keyboard to operate this utility.
Starting the utility
This section describes how to start LSI Software RAID Configuration Utility.
1. Start the remote console, and then power on the server blade.
Click Power > Power On in the tool bar of the remote console.
2. When <F1>Setup is shown during the server blade startup, press F1.
3. UEFI setup menu starts up and System Configuration and Boot
Management window appears.
6-4
LSI Software RAID Configuration Utility for disk arrays
Hitachi Compute Blade 500 Series EFI User's Guide