Hitachi Compute Blade 500 Series - Page 397

Tip:
• Only Unconfigured Good physical drives can be selected.
•
To cancel a selected drive, select the drive and press the space key.
7. Select Drives Target ID: 1: SATA (a drive in slot 1) SATA, xxxx.xxxx
GB,
Unconfigured Good (a drive recognized as Unconfigured Good).
Press the space key.
Tip:
• Only Unconfigured Good physical drives can be selected.
•
To cancel a selected drive, select the drive and press the space key.
8. Select all drives required for virtual drive configuraion. Then select Apply
Changes and press Enter.
9. Virtual Drive Management > Create Configuration > Select Drives >
Success message appears. With OK selected, press Enter.
10. The window returns to Create Configuraion. Select Save Configuration
and press Enter.
11
. Virtual Drive Management > Create Configuration > Warning appears.
Select Yes and press Enter.
Tip: When you select No, the configuration will not saved and the window
returns to Create Configuration window.
12. Virtual Drive Management > Create Configuration > Success message
appears. With OK selected, press Enter.
LSI Software RAID Configuration Utility for disk arrays
6-19
Hitachi Compute Blade 500 Series EFI User's Guide