Hitachi Compute Blade 500 Series - Page 480

Tip: The location of a controller (Bus/Dev) is variable with the I/O devices
on a server blade. Confirm the I/O devices on a server blade to select a
controller.
2. Move cursor to Personality by
Tab. After that, select iSCSI by ↑ and ↓,
then press Enter.
3. Move cursor to Save and press Enter.
4. When the following message is shown, press Y
key.
– Firmware version: 4.1.334.28 or 4.1.334.2801
The system must reset immediately if changing Personality,
continue?
Press Y
key, and the system automatically restarts.
– Firmware version: 4.2.433.604
If changing Personality, no further configuration can be done
on this Controller until a system reset, continue?
Press Y key to return to the window in Step 3. Terminate the utility
manually.
Tip:
•
A firmware version is shown on the top of the utility window as the
following format.
Emulex PXESelect Utility vXXXXXXXX
(XXXXXXXX: firmware version)
•
When terminating the utility manually, press Esc several times to show
the following message and press Y key.
Do you want to exit from the utility [Y/N]?
9-4
iSCSI settings
Hitachi Compute Blade 500 Series EFI User's Guide