103
9. Troubleshooting
9. Troubleshooting
Phenomenon: Cannot communicate with the projector. Wired network)
Item to be checked Solutions
Is the projector turned on" Turn on the projector.
Is the network deYice such as a
router, etc. turned on"
Turn on the network deYice.
Is STAND%Y MODE set to
NETWORKWO/) or SA9IN*"
The network function is not aYailable when
STAND%Y MODE is set to NETWORKWO/)
or SA9IN*. If you want to use the network
function in the standby mode, set to NORMA/.
Is /AN cable connected" Connect the /AN cable.
Is MAC address displayed
correctly in the NETWORK
INFORMATION - WIRED
INFORMATION menu"
Contact your dealer when MAC address on
the label put on the projector does not match
MAC address displayed in the NETWORK
INFORMATION - WIRED INFORMATION
menu.
Are the network settings such as
IP address set correctly"
Check the network settings in the NETWORK
INFORMATION - WIRED INFORMATION
menu. Consult with your network administrator
for details.
Is ¿rewall or packet ¿ltering set in
a router, etc."
Consult with your network administrator.
Is the same network address set
for wireless /AN and wired /AN
of the projector"
The same network address cannot be used
for wireless /AN and wired /AN. Set different
network address for wireless /AN and wired /AN.
Is the wired network adapter of
the computer enabled"
Refer to the user’s manual of the computer and
enable the wired network adapter.
To Next Page
Loading...
