Hitachi CP-EX3051WN - Page 104

104
9. Troubleshooting
Phenomenon: Cannot communicate with the projector. Wireless network)
1. Common
Item to be checked Solutions
Is the projector turned on" Turn on the projector.
Is the network deYice such as an
access point, etc. turned on"
Turn on the network deYice.
Is STAND%Y MODE set to
NETWORKWO/) or SA9IN*"
The network function is not aYailable when
STAND%Y MODE is set to NETWORKWO/)
or SA9IN*. If you want to use the network
function in the standby mode, set to NORMA/.
Are the network settings such as
IP address set correctly"
Check the network settings in the NETWORK
INFORMATION - WIRE/ESS INFORMATION
menu. Consult with your network administrator
for details.
Is the US% wireless adapter
optional parts : US%-W/-5*)
inserted into USB TYPE A port of
the projector"
Insert the US% wireless adapter.
Is an optional US% wireless
adapter used"
The US% wireless adapter aYailable to this projector
is optional US%-W/-5* only.
Is /ED of the US% wireless
adapter blinking"
When /ED of the US% wireless adapter does not
blink in oYer 1 minute after inserting, pull out and
insert the US% wireless adapter again.
If the problem persists, the US% wireless adapter
may be broken. Contact your dealer.