Hitachi CP-EX3051WN - Page 110

110
9. Troubleshooting
Phenomenon: The schedule is not executed correctly.
Item to be checked Solutions
Is the projector turned on" Turn on the projector.
Is STAND%Y MODE set to
NETWORKWO/) or SA9IN*"
The schedule function is not aYailable when
STAND%Y MODE is set to NETWORKWO/)
or SA9IN*. If you want to use the schedule
function in the standby mode, set to NORMA/.
Is the time set correctly" Check the settings of Date and Time.
Is the image data to be displayed
in the schedule function
registered"
When the eYent of My Image is
set.)
Register the image data to be displayed with
the projector by using exclusiYe application
software.
Is the message data to be
displayed in the schedule
function registered"
When the eYent of Messenger is
set.)
Register the message data to be displayed with
the projector by using exclusiYe application
software.
Is the lamp of the projector
lighting"
The eYent of My Image, Messenger and %lank
are not executed when the lamp is not lighting.
Set the program of the schedule function so
that the eYent of MyImage, Messenger and
%lank can be executed when the lamp is
lighting.
Is the program to be executed
set correctly"
Check the settings of Schedule Settings of the
Projector Web Control.
Are there any eYents set at the
same time"
Some eYents cannot be executed at the same
time.
Set them to be executed at the different time or
change the order.
* The schedule function may not operate correctly depending on the status of the
projector.