Hitachi CP-EX3051WN - Page 111

111
9. Troubleshooting
Phenomenon: The time settings are not correct.
Item to be checked Solutions
Is the date and time set correctly" Check the settings of Date/Time Settings menu
of the Projector Web Control or DATE AND
TIME menu of the projector.
Is the projector connected to the
network correctly when getting
the time Yia the network"
Connect to the network.
Is SNTP serYer set correctly
when getting the time Yia the
network"
Check the settings of SNTP serYer.
Consult with your network administrator
regarding the settings of SNTP serYer.
Is the time difference set correctly
when getting the time Yia the
network"
When getting the time Yia the network,
the correct time is not displayed if the time
difference is not set.
Set the time difference.
Phenomenon:

Cannot control the external deYice by using Network %ridge.
Item to be checked Solutions
Is Network %ridge settings
enabled"
Check the settings in OPTION - SER9ICE -
COMMUNICATION - COMMUNICATION TYPE
menu.
Is STAND%Y MODE set to
NETWORKWO/) or SA9IN*"
The Network %ridge is not aYailable when
STAND%Y MODE is set to NETWORKWO/)
or SA9IN*. Set STAND%Y MODE to NORMA/,
and set NETWORK %RID*E WIRE/ESS/
WIRED) in the COMMUNICATION TYPE
menu.
Are the serial settings set
correctly"
Check the serial settings of the projector and
the external deYice.