15
2.1.1 Connection in Simple Access Point Mode
Set the following when connecting the projector and the computer in Simple
Access Point mode.
Projector setting
1) Turn on the projector.
2) Press the MENU button on the remote control
or the control panel of the projector.
The MENU you last used will appear.
Use the cursor button to select the following.
EASY MENU ! AD9ANCED MENU !
NETWORK > NETWORK SETUP >
WIRE/ESS SETUP
3) Set the following items in WIRE/ESS SETUP.
MODE: SIMP/E ACCESS POINT
IP ADDRESS
SSID
SSID %ROADCAST
ENCRYPTION
Select APP/Y, then press the ENTER button to reÀect the settings.
As for the procedure of setting network and wireless connection for the
computer, refer to the manual of the computer or wireless /AN deYice.
Up to 10 deYices can be connected to the projector in Simple Access Point mode.
About network settings
䡡㻌The fourth octet of the projectors IP address is ¿xed to 1.
䡡㻌Subnet mask of the projector is ¿xed to 255.255.255.0.
Computer setting
1) The DHCP serYer function of the projector is always enabled. Enable the DHCP
setting of the computer.
2) Select SSID set for the projector by following the procedure of wireless
connection of the computer. Enter encryption key by following the computer’s
instruction if it is encrypted.
NOTE
2. Connection to the network
To Next Page
Loading...
