51
3.1.6 Alert Settings
Con¿ gures noti¿ cations of errors/warnings.
Refer to chapter “8.1 E-mail Alerts” for the details of the aboYe errors/warnings.
When changing the settings, click the [Apply] button to reÀ ect the settings of the
projector.
This setting can be restored to the initial setting when clicking the [Reset] button.
3. Web Control
3.1 Projector Web Control (continued)
Item Description
Alarm Time *1 Con¿ gures the time to alert.
SNMP Trap *2
Click the [Enable] check box to enable SNMP Trap
alerts.
Send Mail Click the [Enable] check box to enable e-mail alerts.
Mail Subject *3 Con¿ gures the subject line of the e-mail to be sent.
Mail Text *4 Con¿ gures the text of the e-mail to be sent.
*1 Only /amp Time Alarm and Filter Time Alarm.
*2 The setting item of Cold Start and Authentication Failure is SNMP Trap only.
*3 The text length can be up to 100 alphanumeric characters and symbols. Using
any Multi-byte character may shorten the text. Only symbols “)*,-
./:< >"#[?]AB^_`a and space” can be used.
*4 The text length can be up to 1024 alphanumeric characters and symbols. Using
any Multi-byte character may shorten the text. Only symbols “)*,-
./:< >"#[?]AB^_`a and space” can be used.
To Next Page
Loading...
