87
With using the HA/F-DUP/E; method, the projector can send out
254 byte data at the maximum at a time.
If it is not reTuired to monitor the response data from an external deYice and
the RESPONSE /IMIT TIME is set to OFF, the projector can receiYe the data
from the computer and send it out to an external deYice continuously.
The OFF is selected as the default setting.
When the computer controls the synchroni]ation of receptions and transmissions,
the external deYice may not be controlled properly depending on the status of data
processing of the projector.
NOTE
NOTE
7.4.2 FULL-DUPLEX
This method lets the projector make two way communication, transmitting and
receiYing data at the same time, without monitoring response data from an
external deYice.
With using this method, the computer and an external deYice will send the data
out of synchroni]ation. If it is reTuired to synchroni]e them, set the computer to
make the synchroni]ation.
7. Network Bridge Function
7.4 Transmission method (continued)
To Next Page
Loading...
