Hitachi CP-WX3011N - Replacing the Internal Clock Battery

16
OPEN
CLOSE
90°
OPEN
CLOSE
OPEN
CLOSE
OPEN
CLOSE
90°
O
P
E
N
C
L
O
S
E
1.
Turn the projector off, and unplug the
power cord. Allow the projector to cool
VXI¿FLHQWO\
2.
After making sure that the projector has
cooled adequately, slowly turn over the
projector, so that the bottom is facing.
3.
Turn the battery cover fully in the direction
LQGLFDWHG³23(1´XVLQJDFRLQRUWKHOLNH
and pick the cover up to remove it.
4.
3U\XSWKHEDWWHU\XVLQJDÀDWKHDG
screwdriver or the like to take it out. While
SU\LQJLWXSSXWD¿QJHUOLJKWO\RQWKH
battery since it may pop out of the holder.
5.
Replace the battery with a new
HITACHI
MAXELL, Part No. CR2032 or CR2032H .
Slide the battery in under the plastic claw,
and push it into the holder until it clicks.
6.
Replace the battery cover in place, then
WXUQLWLQWKHGLUHFWLRQLQGLFDWHG³&/26(´
XVLQJVXFKDVFRLQVWR¿[
WARNING Ź%HFDUHIXORIKDQGOLQJDEDWWHU\DVDEDWWHU\FDQFDXVH
H[SORVLRQFUDFNLQJRUOHDNDJHZKLFKFRXOGUHVXOWLQD¿UHDQLQMXU\DQG
environment pollution.
8VHRQO\WKHVSHFL¿HGDQGSHUIHFWEDWWHU\'RQRWXVHDEDWWHU\ZLWKGDPDJH
such as a scratch, a dent, rust or leakage.
:KHQUHSODFLQJWKHEDWWHU\UHSODFHLWZLWKDQHZEDWWHU\
 When a battery leaked, wipe the leakage out well with a waste cloth. If the
leakage adhered to your body, immediately rinse it well with water. When a battery
leaked in the battery holder, replace the batteries after wiping the leakage out.
0DNHVXUHWKHSOXVDQGPLQXVWHUPLQDOVDUHFRUUHFWO\DOLJQHGZKHQORDGLQJD
battery.
'RQRWZRUNRQDEDWWHU\IRUH[DPSOHUHFKDUJLQJRUVROGHULQJ
.HHSDEDWWHU\LQDGDUNFRRODQGGU\SODFH1HYHUH[SRVHDEDWWHU\WRD¿UH
or water.

.HHSDEDWWHU\DZD\IURPFKLOGUHQDQGSHWV%HFDUHIXOIRUWKHPQRWWRVZDOORZ
a battery. If swallowed consult a physician immediately for emergency treatment.
2EH\WKHORFDOODZVRQGLVSRVLQJDEDWWHU\
Replacing the internal clock battery
%DWWHU\FRYHU
This projector has internal clock that uses a battery. When the clock of the network
function does not work correctly, please try solution by replacement of the battery:
HITACHI MAXELL, part number CR2032 or CR2032H.
NOTE7KHLQWHUQDOFORFNZLOOEHLQLWLDOL]HGE\UHPRYLQJWKHEDWWHU\)RU
VHWWLQJWKHFORFNVHH³1HWZRUN*XLGH´
(

17, 19)