Operating
1.
Press BLANK button on the remote control.
The BLANK screen will be displayed instead of the screen
of input signal. Please refer to BLANK item in SCREEN
menu (37).
To exit from the BLANK screen and return to the input signal
screen, press BLANK button again.
Temporarily blanking the screen
● The projector automatically exits from the
BLANK
mode when
some control buttons are pressed.
•
The sound is not connected with the BLANK screen function. If
necessary, set the volume or mute rst. To display the BLANK screen and mute
the sound at one time, use AV MUTE function
(43).
NOTE
1.
Press the FREEZE button on the remote control.
The “FREEZE” indication will appear on the screen (however,
the indication will not appear when the TURN OFF is
selected for the MESSAGE item in the SCREEN menu
(
39)), and the projector will go into the FREEZE mode,
which the picture is frozen.
To exit the FREEZE mode and restore the screen to normal,
press the FREEZE button again.
Freezing the screen
● The projector automatically exits from the FREEZE mode when some control
buttons are pressed.
● If the projector continues projecting a still image for a long time, the LCD
panel might possibly be burned in. Do not leave the projector in the FREEZE
mode for too long.
FREEZE button
To Next Page
Loading...
