Hitachi DZ-GX5020A K - 4-3-1 Displaying error codes and clearing them; 4-3-2 Details of error code display; 4-3-3 Major error codes and troubleshooting

4 - 13
Fig. 4-3-1 Example of Error Code Display
4-3-2 Details of error code display
Up to eight error codes of problems can be displayed
with the dates/times when the problems occurred.
If the same problem occurs repeatedly, it will be
judged as one problem, and the same error code will
not continue to appear.
If more than eight problems occur, the error codes
will be erased beginning with the oldest problem,
and the code for the newest problem will be recorded.
If no error code is recorded, the line for error code
and problem occurrence date/time will be all zero (0).
Information:
To erase all error codes and reset to the default
status, perform system reset (remove the battery and
AC adapter/charger, and use a fi ne-tipped pen to hold
down the reset button for several seconds).
4-3-3 Major error codes and troubleshooting
Table 4-3-1 shows the error codes that are likely to frequently appear, and appropriate
troubleshooting.
If error codes other than those listed in Table 4-3-1 appear, check with the factory for
troubleshooting.
Table 4-3-1 Major Error Codes and Troubleshooting
Troubleshooting > Display of Error Codes and Troubleshooting
Error code Contents of problem Troubleshooting
0200 Optical pickup failed to move. Refer to “4-3-4 Disc load check fl owchart”
0280
0400 Recognition of disc failed.
0401 Optical pickup was faulty. Replace the DVD drive unit.
040D No disc Load a disc.
1001 DVD-RW/+RW was not formatted.
(*1)
Format the DVD-RW/+RW
1100 Reading data from disc failed. Refer to “4-3-4 Disc load check fl owchart”
2881 Recognition of disc failed. Refer to “4-3-4 Disc load check fl owchart”
3105 Recording photos failed because of
condensation in DVD drive unit
(optical pickup) or dirt on optical
pickup.
Set the power switch to “OFF”, and then leave the DVD
video camera/recorder in a dry place until condensation
disappears (for at least 1-2 hours).
Clean the optical pickup, referring to “4-3-5 Cleaning
disc and optical pickup”.
3122 Recording on disc failed because
it was subject to vibrations or impact
when it was being accessed.
Any vibration or impact to disc while it is being accessed
will result in no recording.
Error Code
RETURN
[Error Code] Date Time
[0400]11111405
[0401]01010905
[0000]00000000
[0000]00000000
[0000]00000000
[0000]00000000
[0000]00000000
[0000]00000000
[0 4 0 0] 1 1 1 1 1 4 0 5
Min
Hore
Day
Month
Problem occurrence
date/time
Error code