4 - 34
Troubleshooting > Procedure for Removing Disc from Faulty DVD Video Camera/Recorder
4-6
Procedure for Removing Disc from Faulty DVD Video
Camera/Recorder
4-6-1
Items to be checked
Connect the AC adapter/charger or charged battery (power supply), make sure that the ACCESS
indicator turns off, and then press the DISC EJECT button again.
Even with normal product, the disc cannot be removed while the ACCESS indicator is lit or blinking.
Information:
Be sure to connect the AC adapter/charger or charged battery pack (power supply) before pressing
the DISC EJECT button.
The DISC EJECT button will not work unless a power supply is connected.
4-6-2
How to remove disc
If the disc cannot be removed after performing “4-6-1 Items to be checked”, remove it using the
procedure in this section.
Cautions
Laser light striking the eye may cause your eyesight to be lost: For safety, be sure to remove any power
supply (AC adapter/charger, battery, etc.) from the DVD video camera/recorder before starting work.
Information:
1) The DZ-GX5080A is used for explanation in
this section. Although the shapes of parts
are slightly different for each model, the
procedure is identical for all models.
2) Numbers in the procedural diagram are
step numbers of procedure, and letters in
brackets [ ] show the types of screw.
1) Remove screw [A].
2) Remove the lens cover (a) in the direction of
the arrow.
3) Remove the top cover (b) in the direction of
the arrow.
4) Use a fi ne-tipped fl at-bladed screwdriver, etc.
to move the lock slider (c) in the direction of
the arrow, and then open the disc cover.
5) After removing the disc, close the disc cover.
When reassembling the removed parts, use
the reverse procedure to removal.
Fig. 4-6-1 How to remove disc
(a)
2)
3)
(b)
1) [A]
(c)
4)
(a) Lens cover
(b) Top cover
(c) Lock slider
[A] M1.7x4(Silver)
To Next Page
Loading...
