Hitachi DZ-GX5080A - Program; WHAT IS PROGRAM?; SWITCHING TO THUMBNAIL DISPLAY OF SPECIFIC DATE (SELECT)

6 - 1
Adjustment
6
6-1 Creating Reference Data
The reference data is necessary for adjustment: The adjustment software will not operate normally
without it. Before adjustment, be sure to create the reference data, using the same model (with
normal camera block) as the one to be adjusted.
The reference data is used to reduce the difference between environments of servicing site and
factory (color temperature of light box, etc.). Using the reference data will increase adjustment
accuracy.
6-1-1 Checking Reference Data
Before starting adjustment, check whether it will be necessary to create the reference data or not,
referring to the fl owchart below:
Fig. 6-1-1 Reference Data Check Flowchart
Have you ever created
reference data for
this model?
Yes Will you use
the same PC as when
you created the
reference data?
Ye s
Ye s
No
No
Ye s
No
Use the reference data
created in the past to
perform adjustment.
Ye s
No
Create the reference data.
No
Ye s
Does the "map07w"
folder exist on HDD
of PC used to create
the reference data?
Copy the "map07w" folder
from the PC on which you
created the reference
data.
Will you use the same
light box as when you
created the reference
data?
Did you perform
maintenance on the light
box after creating
the reference data?
No
Ye s
Will you use the same
C12 light balancing
filter as when you
created the reference
data?
Creation of reference
data needed or not
Create the reference data.