6 - 14
Adjustment > Setups for Adjustment
6-2-4
Settings for Adjustment
When the connections for adjustment are complete, set the DVD video camera/recorder and test
equipment as follows:
(1)
Setting the DVD video camera/recorder
Information:
This item is the same as when creating reference data.
1) Make sure that no disc or card is inserted: Neither is necessary when adjustment.
2) Set the power switch to “Movie”: After that operate the DVD video camera/recorder while
watching the LCD monitor screen.
3) Press the MENU button to display the camera function setup screen.
4) Use the
/ / / buttons to choose “Initial Setup”, and then press the button.
5) Use the / / / buttons to choose “Reset”, and then press the button.
6) Use the / / / buttons to choose “YES”, and then press the button.
7) When reset is complete, use the above procedure to operate the / / / buttons and set
16:9 in the Recording Function Setup manu to “off”, set Demo Mode in the Initial Setup menu to
“Off”: Forgetting to set it to “Off” will cause a problem during adjustment.
8) Press the MENU button to restore the normal display.
Information:
The following table shows the menu status after the above settings:
The settings for Date Setup are not shown in the table below, since they do not have any meaning
when adjusting.
Item Setting
Camera Functions Setup
Program AE Auto
White Bal. Auto
EIS On
Dig. Zoom 100×/120×
(*1)
MIC Filter Off
Recording Functions Setup
VIDEO Mode FINE
Quality FINE
16:9
Off
Self Timer Off
OSD Output Off
Item Setting
LCD/EVF Setup
LCD Brightness
EVF Brightness
Color Level
EVF Display Auto
Initial Setup
Beep On
Power Save Off
Record LED On
Language English
Demo Mode
Off
*1: 100x will appear on DZ-GX5000A; and 120x
on DZ-GX5080A/DZ-GX5020A.
To Next Page
Loading...
