Turning DVD Video Camera/Recorder On and
Off
While holding down the gray button at the right
of power switch, set the switch according to
each recording function:
Set to "OFF":
Tile DVD video camera/
recorder will turn off
Set to "D":
To record still on SD
Illen/O rv card
Set to "411":
To record movie on DVD-
RAM/DVD-RW/DVD-R/
+RW disc
-Set to "1_1":
To record still on DVD-
RAM disc
Note:
• Once you turn the DVD video camera/recorder on to
let it recognize the disc, you can immediately record
or play back by turning the DVD video camera/
recorder on again. However, if a long time has
elapsed after the disc was inserted, it will take some
time for the DVD video camera/recorder to start
because it must recognize the disc again (see
"Troubleshooting" on page 135),
• It will take some time for the DVD video camera/
recorder to display the Disc Navigation screen after
power is turned on,
• When the DVD video camera/recorder is turned on,
the self-diagnosis function will work and a message
may appear. In this case, refer to "Trouble Messages"
on page 129 and take corrective action.
PowerON status
During playback, set the power switch to %1'
or "1_1"when using disc, or set it to "[i_ril"when
using card.
Turn the switch while
holding down the gray
button at the right of switch,
Power switch
29
To Next Page
Loading...
