RESETTING MENU SETTINGS TO DEFAULTS (RESET)
You carl restore menu settings to defaults (initial settings at the factory (p. 142)). (Note, howex er, that
the date/time will not be reset.)
1Choose "Reset" on the
"Initial Setup" menu
screen, and then press
the l,,/ll button.
The screen_ for verifying., reset_ will aFp_ ear.
2 If you are sure that you
wish to reset, use the
button to choose
"YES", and then press
the I_/11 button.
i _._Reset _
_R _
The setting items ha_e now been reset to
defaults.
Note:
To cancel resetting midway, choose "NO" on the screen
for verification in step 2 or press the • button.
TURNING RECORD LED ON OR OFF (RECORD LED)
You can switch off the recording indicator on the front of DVD _ideo camera/recorder e_en during
recording.
Select "On" or "Off", and
then press the I'/11 button.
On: The recording
indicator will light
red to show that the
DVD video camera/recorder is recording.
Off: The rocording indicator will not light even
during recording.
Note:
• The Record LED setting will not appear in the on-
screen information display,
• The Record LED setting will be stored in memory
even when the DVD video camera/recorder is turned
off.
• Specify "Record LED: Off" when recording a subject
behind a glass or water tank that reflects light: The
reflected light of the recording indicator will not be
recorded,
• Even if "Record LED Off" is specified, the recording
indicator will light while the self-timer is counting
down.
CHANGING SETTING OF DEMONSTRATION
1Press the MENU
button, choose "Initial
Setup", "Demo Mode",
and then press the I1,'/11
button.
2 Press the I_1 or D,'I_Ibutton to choose the
desired option, and then press the I_/11
button.
Auto: To start demonstration if the DVD
video camera/recorder is inactive for
approx. 3 minutes after it is turned on.
Off: To set demonstration to off.
Start: Tostart demorlstrationimmediately.
Note:
• Pressing the • (STOP/EXIT) or DISC NAVIGATION
button will exit demonstration.
• If you choose "Auto" the demonstration will not start if
a disc is loaded with the power switch set to "_,4_"or
'1_1",or a card is loaded with the power switch set to
• The demonstration function will not work when the
DVD video camera/recorder is connected to PC (DZ-
GX5080A only).
• While the demonstration is being given, the recording
indicator will blink.
3 Press the MENU button again to exit setting.
33
To Next Page
Loading...
