|
Inserting and Removing Disc
4
/ Press down tile DISC EJECT button once and
release it.
A few moments after tile ACCESS/PC
indicator blinks, the cover of disc insertion
block will open.
2 Gently open tile cover by hand fully until it
stops.
3 When inserting a disc:
Push the disc against the turntable at the
center to lock it until a click is heard.
Push the shaded
portion.
When removing the disc:
While pushing down the center portion of
turntable, pick up the disc, holding iN edge,
to renlo_, e it.
Pickup
lens
• Note that the recording surface of disc must face
the inside of DVD video camera/recorder. When
using a single-sided disc, the recording surface is
the side without label,
• Never touch the disc recording surface or pickup
lens. Touching the pickup lens could cause a fault.
• Use the disc cleaning cloth provided to wipe off
any dirt adhering to the disc recording surface.
• De not use a dirtied or scratched disc.
4 Push the section nrarked "PUSH CLOSE" on
the cover of disc insertion block, to close the
cover,
Then the DVD video camera/recorder will
automatically recognize the disc: While the
ACCESS/PC indicator is lit, do not cut off the
power supp]_, and do not subject the DVD
video camera/recorder to any vibrations or
impact.
Turntable
36
To Next Page
Loading...
