Hitachi DZ-HS300A - Recording Subjects for Stronger Wide-Angle or Telephoto Effect

English
54
RECORDING SUBJECTS FOR STRONGER WIDE-ANGLE OR TELEPHOTO
EFFECT
Use the tele-conversion lens or wide-conversion lens with the following filter diameter and thread
pitch to record subjects for stronger telephoto or wide-angle effect:
Filter diameter: 37 mm for DZ-HS303A; 34 mm for DZ-HS300A
Thread pitch: 0.75 mm for DZ-HS303A; 0.5 mm for DZ-HS300A
When attaching the optional DZ-TL1 tele-conversion lens or DZ-WL1 wide-conversion lens, use the
optional step-up ring: DZ-SR3437 for DZ-HS300A (see page 138).
1 Remove the lens hood from DVD video
camera/recorder, and attach the step-up ring
over the lens.
2 Remove the cap of conversion lens, and screw
the lens into the thread of step-up ring.
When using the DZ-HS303A, you need not
use the step-up ring.
Note:
• Be careful not to lose the removed lens hood.
• With DZ-TL1 tele-conversion lens, the focusing range
at “T” (telephoto) control side is between approx.
16 feet (5 m) and infinite.
• When a conversion lens is attached, note that the four
corners of screen will be slightly dim if you zoom in on
a subject on the W control side (wide-angle side).
• When replacing the lens, take care not to drop the
DVD video camera/recorder.
• Attaching the conversion lens will disable the function
of the built-in flash (for DZ-HS303A only): Specify
“Flash: Off” (see page 59).
• If a generally available filter is attached, do not attach
the removed lens hood.
• Some generally available conversion lenses may not
be usable on this DVD video camera/recorder,
depending on the lens maker.
• Tele-conversion lens: For stronger telephoto effect
• Wide-conversion lens: For stronger wide-angle effect
(Attach)
Conversion lensLens hood
(Remove)
Step-up ring
(only when using DZ-
HS300A)