14
English
STOPPING THE GENERATOR
1. Turn off the power switch of the electric equipment or unplug the cord from
receptacle of the generator.
2. Allow the engine about 3 minutes to cool down at no-load before stopping.
3. Set the engine switch to “STOP” position.
4. Close (stop) the fuel cock.
OIL SENSOR
● The oil sensor detects the fall in oil in the crankcase and automatically
stops the engine when the oil level fails down below the safety limit.
● When engine has stopped automatically, check the oil level.
● If the engine does not start by usual starting procedures, check the oil
level.
● Run
ON
OFF
1
CLOSE
RECOMMENDED OIL LEVEL
OIL LEVEL
FLOAT SWITCH
OFF
Fig. 20
Fig. 21
Fig. 22
Fig. 23
● Stop
Oil Level
OIL LEVEL
ON
Fig. 24
To Next Page
Loading...
