Hitachi EH-150 Series - Page 185

Appendix
A - 21
Task code
HA0
Monitoring with I/O number designation
(Series N points)
Classification
I/O Control
 Function
Reads N continuous points (words) of monitor data, starting with the designated I/O number.
* This task code can also be executed when the CPU is not occupied.
* The I/O data of EH-150 outside the range returns all off (0).
 Execution condition
CPU Status
Occupation
STOP RUN HALT
ERROR
READ occupation
   
WRITE occupation
   
Not occupied
   
 Request format
H A 0
(a)
(b)
(c)
(a) I/O code (refer to the I/O code table)
(b) I/O number (refer to I/O number
decimal/hexadecimal conversion chart)
(c) Number of bits H01 to HF0 (1 to 240)
Number of words H01 to H78 (1 to 120)
 Response format
(a)
H A 0
(b)
(a) Response task code (H00 when executed normally)
For task codes other than the normal task codes, refer to
the “response list by task code” at the end of this chapter.
(b) Monitor data
(Bit data)
1st point
2nd point
3rd point
8th point
Binary image (H00 to HFF)
bit7
bit0
Number of points / 8
* When the number of monitor points is
less than 8 points, the open bits are set
to “0” (H00 to HFF).
(Word data)
Binary image (H0000 to HFFFF)
Number of words
H
L
1st word
Nth word
 Example
Read 16 points from M40. (M40=1, M41 - M4F=0)
Request : STX 2 FFFF0000 A0 04 000040 10 64 CR
Request (ASCII) : 02 32 4646464630303030 4130 3034 30303030303430 3130 3634 0D
Response : STX FFFF0000 00 A0 8000 BCC CR