Chapter 10 Troubleshooting
For reference
In order to check the network connection, the "ping" command is useful.
You can simply type “ping” and IP address in Command Prompt. If the network is on line, the requested
station will reply as below. In this sample, the DIP Switch configuration is Bit 1=ON, Bit 8=ON, the
other=OFF, which means temporal IP address is 192.168.0.1.
[Procedure]
(1) Select [Start]-[Programs]-[Accessories]-[Command Prompt]
(2) Type “ ping 192.168.0.1 “
(3-1) If the network is on line, EH-ETH2 will reply as below.
(3-2) If the network is off line, EH-ETH2 will reply as below.
10-4
To Next Page
Loading...
