Hitachi G1500 - Work Safety Guidelines; Warning About Moving Parts

Work safety guidelines
Observe the following site guidelines:
■
Do not wear loose clothing that could get caught in the equipment or mounting
hardware. Fasten your tie or scarf and roll up your sleeves.
■
Wear safety glasses when working under conditions that are hazardous to your eyes.
■
Do not perform any action that creates a potential hazard to people or makes the
equipment or rack unsafe.
■
Keep walkways clear of tools, power cables, and parts to prevent them from being
stepped on or causing people to trip and fall over them.
■
Do not work on the equipment or disconnect cables during a thunderstorm, when
wearing a wool sweater or other heavy wool clothing, or when power is applied.
■
Keep oors dry to prevent slips and falls.
■
Do not use ungr
ounded po
wer cables.
■
Keep the ar
ea clear and dust-fr
ee during and after installation.
■
Do not block or cover equipment openings. Ensure that all equipment has adequate
airow. Failure to follow these guidelines can cause overheating and aect the system
reliability.
■
If you notice unusual heat generation, odors, or smoke emission, shut o the power
feed to the equipment and contact a maintenance engineer. Leaving such conditions
unattended can result in hazardous physical conditions and equipment failure.
■
The rack is equipped with casters so that it can be moved short distances to position
it for nal installation. Use enough personnel (minimum of two) when moving a rack,
especially on sloping loading docks and ramps to a raised computer room oor. Move
the cabinet slowly and deliberately, and make sure that the oor is free from foreign
objects and cables that the cabinet could roll over.
Warning: T
o avoid injury
, wear pr
otective footwear when mo
ving equipment.
Warning about moving parts
Even though customers do not install or maintain equipment, these guidelines are
provided to prevent possible injury when working with authorized service personnel.
Observe the following warning related to moving parts:
■
Tuck in any loose clothing so that it cannot be caught by a moving or rotating part
such as a fan.
■
Tie up long hair.
■
Unless otherwise specically instructed, do not supply power to any device that
contains r
otating or mo
ving parts that ar
e not corr
ectly covered.
Work safety guidelines
Appendix G: Safety requirements
Hitachi Virtual Storage Platform G1000, G1500, and VSP F1500 Hardware Guide 164