3. On the SVP
, exit to a Windows command prompt as Administrator.
4. Move to the directory where the tool exists, and then issue the following
command:
C:\MAPP\wk\Supervisor\MappIniSet\MappBackup.bat [absolute
path of the backup (tgz zip) file]
5. When the completion message appears, press an
y key to continue.
6. Exit the command prompt.
7. Move the configuration file from the SVP to a USB flash drive.
Note: Do not edit the contents of the backup file.
Restoring the SVP configuration
If y
ou backed up the SVP configuration, you can use the following procedure
to restore the configuration. This procedure is particularly useful when you
receive a replacement SVP and want to install a configuration that was used
on your previous SVP.
This procedure assumes that:
• The client PC is connected to the SVP using a Remote Desktop Connection.
• The storage system you want to restore is registered on the SVP.
• The service setting is configured to not start automatically when the SVP
reboots.
To restore the SVP configuration:
Procedure
1. Copy the backup file to a folder on the SVP.
2. On the SVP, exit to a Windows command prompt as Administrator.
3. Move to the directory where the backup file exists, and then issue the
following command:
C:\MAPP\wk\Supervisor\MappIniSet\MappRestore.bat[absolute
path of the backup (tgz zip) file]
4. When the restor
ation message appears, press any key to continue.
5. Exit the command prompt.
6. Atach a USB flash drive to a USB port on the SVP, and then move the
backup file from the SVP to the USB flash drive.
7. Configure the service setting to start automatically the next time the SVP
reboots, and then reboot the SVP.
SVP support 45
Hitachi Virtual Storage Platform G200, G400, G600 Service Processor Technical Reference
To Next Page
Loading...
