Error code
(SSB2)
Description
C388 The pair cannot be created because the emulation type is not available for the specified
volume.
C38B The secondary system is already used by TC.
C38D The S-VOL is not available.
C38E The S-VOL is not supported by TC.
C390 The S-VOL status is not PSUS or PSUE.
C391 The S-VOL cannot be copied to because it is in the wrong pair status.
C392 The volume cannot be used as an S-VOL because it is in reserve status, is already being
used by TC, or is being used by UR.
C393 The S-VOL includes PIN data.
C395 The create or resync TC pair command was rejected due to blockage of the specified S-
VOL, physical volume with the S-VOL being blocked, correction access, or other
reasons.
C398 The pair cannot be created because the emulation type is not available for the specified
volume.
C39B An internal error occurred.
C39E The pair cannot be created because the capacity of the P-VOL exceeded the maximum
volume capacity allowed to create a TC pair.
C39F The pair cannot be created because the capacity of the S-VOL exceeded the maximum
volume capacity allowed to create a TC pair.
C3A0 The P-VOL is a device not supported by TC.
C3A6 The CU number of the secondary system is invalid.
C3A8 The device type combination between the P-VOL and S-VOL is invalid.
C3AA The secondary system's cache is blocked on one side.
C3AB The secondary system's cache is blocked on one side.
C3AC TC is not supported for this controller emulation type of the secondary system.
C3AD The secondary system capacity exceeds the license capacity.
C3AE TC is not installed on the secondary system.
C3AF The DKC type of the secondary system is not supported by TC.
C3B1 The number of paths is smaller than the required minimum number of paths.
C3B3 An internal error occurred.
C3B5 The configuration combination of P-VOL and S-VOL is invalid
C3B6 The P-VOL is a SI volume.
C3B7 The S-VOL is a SI volume.
C3B8 An internal error occurred.
10-12
Troubleshooting
Hitachi TrueCopy® User Guide for Hitachi Virtual Storage Platform Gx00 and Fx00 Models