Error code
(SSB2)
Description
CBDC A request for a Paircreate operation was received in the TC-UR combination status.
However, the command was rejected because the Mirror ID of UR was 0.
CBDD In configuring a TC-UR multi-target configuration, a request for a TC Paircreate
operation was rejected because the UR pair was in the process of copying.
CBDE The Paircreate operation cannot run because the P-VOL is used by Thin Image or Copy-
on-Write Snapshot.
CBDF The Paircreate operation cannot run because the S-VOL is used by Thin Image or Copy-
on-Write Snapshot.
CBE0 The Paircreate operation cannot run because the P-VOL is a Thin Image or Copy-on-
Write Snapshot virtual volume.
CBE1 The Paircreate operation cannot run because the S-VOL is a Thin Image or Copy-on-
Write Snapshot virtual volume.
CBE2 The Paircreate operation cannot run because the P-VOL is a Dynamic Provisioning, Thin
Image, or Copy-on-Write Snapshot Pool-VOL.
CBE3 The Paircreate operation cannot run because the S-VOL is a Dynamic Provisioning, Thin
Image, or Copy-on-Write Snapshot Pool-VOL.
CBE7 More than 65,280 pairs cannot be created in one storage system.
CBEB The pair cannot be created because the specified P-VOL is being shredded by Volume
Shredder.
CBEC The pair cannot be created because the specified S-VOL is being shredded by Volume
Shredder.
CBED The paircreate operation cannot run because of one of the following reasons:
• The specified S-VOL is the volume for a UR S-VOL.
• The specified S-VOL is the volume for a UR journal volume.
• An attempt was made to create the 2DC or 3DC configuration using the specified S-
VOL, but a storage system that does not support 2DC or 3DC is included in the
configuration.
CBEE The command was rejected because the pair is already created for the specified P-VOL
by one of the following purpose.
• For differential resync of UR.
• For primary site of 3DC multi-target configuration with 3 UR sites.
CBF3 The pair was not created because the specified P-VOL is either of the following:
• An external volume mapped for moving data online
• An external volume of which data direct mapping attribute is enabled
CBF7 An attempt was made to create the 2DC or 3DC configuration using the specified P-VOL,
but the paircreate operation cannot run because a storage system that does not support
the 2DC or 3DC configuration is included.
CBF8 The pair cannot created because the model or the software version of the primary or
secondary system is not supported.
CBFC The pair cannot be created because the consistency group ID is not within the
supported range.
Troubleshooting
10-15
Hitachi TrueCopy® User Guide for Hitachi Virtual Storage Platform Gx00 and Fx00 Models
To Next Page
Loading...
