10. Hold both ends of the cache memory, and then gently pull out the cache
memory from the socket.
Note: Do not exert pressure on the cache memory. Otherwise, you
can damage the printed circuit board.
11. Align the notch on the cache memory board with the projection inside
the slot.
12. Holding both ends of the cache memory, insert it into the socket.
13. Confirm that the lever is securing the cache memory.
14. Close the air guide.
15. Confirm that the connector of the controller is not damaged, deformed,
or dusty.
16. With the right and left levers of the controller opened completely, insert
it into the slot of the controller.
17. Push the controller all the way into the slot.
The right and left levers close completely.
18. Tighten the blue screw to secure the controller.
19. With the lever on the backup module open, insert the backup module
into the slot.
20. With the backup module lever closed, tighten the blue screw to secure it.
21. Install the four backup modules on the controller.
22. Tighten the blue screw to secure the controller.
23. Confirm that the red CTL ALM LED on the controller in which the cache
memory was installed goes off.
Next steps
• Use the maintenance utility to restore (unblock) the controller.
194 Replacing cache memory
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
