Hitachi G200 - Restoring the SFP+ for a NAS Module

3. On the new SFP+, connect the cable to the same port to which the cable
was connected on the old SFP+. Be sure the cable clicks into place.
Restoring the SFP+ for a NAS module
Procedure
1. In the Maintenance Utility window, click Hardware > Controller
Chassis.
2. Click the CHBs tab.
3. To display the most recent status of the NAS module, click Refresh.
4. Confirm that the status of the replaced SFP+ is Normal.
5. Log out of the Maintenance Utility window.
Replacing a small form-factor pluggable (SFP) 221
Service Guide for VSP Gx00 and VSP Fx00 Models