8. Check that the controller is blocked and becomes ready for replacing the
SAS cables. Leave the Replace Controller Board window open, but do
not click the Restore button.
9. Confirm that the red CTL ALM LED on the controller is on.
10. Release the routing of the SAS cable connected to the CBSS or CBSL.
11. Remove the SAS cable from the back end module on the CBSS or CBSL.
12. Remove the SAS cable from the ENC on the CBSS/CBSL drive tray.
238 Replacing a SAS cable
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
