15. Connect new SAS cables to the back end module on the CBLM/CBLH and
to the ENC of the CBLM/CBLH drive tray.
16. Confirm that the red STATUS LED for the back end module is off.
17. Connect the new SAS cables to the back end module on the CBLM or
CBLH and to the ENC of the drive tray connected to the CBLM or CBLH.
18. Connect the cables to the SAS adapters. When replacing the SAS adapter
for SAS cable DW-F800-SCQ1HA, install the cable into a new SAS
adapter, and then connect it to the ENC.
Note: When connecting the SAS cable DW-F800-SCQ1HA, be sure
the cable latch clicks and the cables are connected securely to the
SAS adapters.
244 Replacing a SAS cable
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
