7. Click Block.
8. Verify that the appropriate ENC is blocked.
9. Leave the Replace ENC window open, but do not click the Restore
button.
10. Confirm that the red ALARM LED on the ENC whose SAS cable you want to
replace is on.
11. Unroute the SAS cable connected to the drive tray.
Note: For SAS cable DW-F800-SCQ1HA, you do not have to
unroute the cable.
12. Remove the SAS cable from the ENC on the drive tray and from the ENC
on a drive tray connected to another drive tray.
13. For SAS cable DW-F800-SCQ1HA:
a. Open the lever securing the ENC. When the lever opens completely,
the ENC is completely pulled out.
b. Wait at least 20 seconds, and then re-insert the ENC until the right
and left levers close slightly, and then push the lever toward the ENC.
Replacing a SAS cable 247
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
