Hitachi G200 - Restoring a Pcie Switch Board

4. Open the PCIe switch board lever completely.
5. Install the PCIe switch board in the set position until its lever closes
slightly, and then push the lever toward the PCIe switch board.
6. Tighten the blue screw and secure the PCIe switch board.
7. Confirm that the red STATUS LED is off at the PCIe switch board.
8. Attach the front bezel.
Restoring a PCIe switch board
Procedure
1. At the Replace PCIe switch board window, click Restore.
2. When the completion message appears, click Close.
Replacing a PCIe switch board 289
Service Guide for VSP Gx00 and VSP Fx00 Models