[2015/03/19 17:12:15.216][ERROR] [TRSDLS000008] [SDLSrv] [ Ready : Failed to
stop. ]
The following table lists troubleshooting codes and recovery actions.
Troubleshooting code Failure level Recovery action
TRSDLS000001 INFO
The initialization processing of
the Storage Device List server
started.
Check that TRSDLS000002 is
output and the initialization
processing completes normally.
TRSDLS000002 INFO
The initialization processing of
the Storage Device List server
completed normally.
TRSDLS000003 ERROR
The initialization processing of
the Storage Device List server
terminated with errors. See the
troubleshooting codes that
were output before and after
this log, and perform the
appropriate recovery actions.
If no other error log is output,
restart the SVP. If the condition
does not change after
restarting the SVP, set it up
again.
TRSDLS000004 ERROR
The port shown in the log
cannot be used.
If the port exists, change the
port number used in the
application when allowed. If
you cannot change the port
number (see Changing SVP port
numbers), change the port
number for DKCManPrivate.
Then perform the following
procedure. If the result does
not change, restart the SVP. If
the condition still does not
change after, set up the SVP
again.
1. From the Windows Start
menu, click Control Panel >
System and Security >
Management Tool > Services.
2. Click DKCMan from the list
and click Start Services.
TRSDLS000005 ERROR
The initialization processing of
the Storage Device List server
timed out.
346 Troubleshooting the storage system
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
