Troubleshooting code Failure level Recovery action
Restart the SVP. If the condition
does not change after
restarting the SVP, set it up
again.
1. From the Windows Start
menu, click Control Panel >
System and Security >
Management Tool > Services.
2. Click DKCMan from the list
and click Start Services.
TRSDLS000006 INFO
Stopping the Storage Device
List server has begun. Check
that TRSDLS000007 is output
and the stop processing
completes normally.
TRSDLS000007 INFO
Stopping the Storage Device
List server completed normally.
TRSDLS000008 ERROR
Stopping the Storage Device
List server terminated with
errors. The port shown in the
log cannot be used. See the
troubleshooting codes output
before and after this log, and
perform the appropriate
recovery actions. If no other
error log is produced, perform
the following procedure to stop
the Storage Device List server.
1. From the Windows Start
menu, click Control Panel >
System and Security >
Management Tool > Services.
2. Show the DKCMan property.
3. On the General tab, set the
Type of Start-up to Manual.
4. Reboot the SVP.
TRSDLS000009 ERROR
The Storage Device List server
cannot be stopped at this time.
Wait a few minutes, and then
try to stop it.
TRSDLS000010 ERROR
The storage system with the
serial number displayed in the
log cannot stop its service.
Perform the following procedure
to stop the Storage Device List
server:
1. From the Windows Start
menu, click Control Panel >
Troubleshooting the storage system 347
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
