Port address mapping
Each fibre channel port has a default port address (AL_PA) of EF. You do not
have to change this value because the storage system port can connect to
the host bus adapter (HBA) with the current setting.
If you want to change the AL_PA value, however, select a value from the
following table.
If you use a value that is not in the following table or is already used by the
HBA, the host might not be able to recognize the VOL. If this problem or
other problems occur, revert to the default value of
EF.
EF* CD B2 98 72 55 3A 25
E8 CC B1 67 7 64 39 23
E4 CB AE 90 6E 53 36 1F
E2 CA AD 8F 6D 52 35 1E
E1 C9 AC 88 6C 51 34 1D
E0 C7 AB 84 6B 4E 33 1B
DC C6 AA 82 6A 4D 32 18
DA C5 A9 81 69 4C 31 17
D9 C3 A7 80 67 4B 2E 10
D6 BC A6 7C 66 4A 2D 0F
D5 BA A5 7A 65 49 2C 08
D4 B9 A3 79 63 47 2B 04
D3 B6 9F 76 5C 46 2A 02
D2 B5 9E 75 5A 45 29 01
D1 B4 9D 74 59 43 27 N/A
CE B3 9B 73 56 3C 26 N/A
* A value set as the default value.
104 Port address mapping
Hitachi Virtual Storage Platform G400, G600 Hardware Reference Guide
To Next Page
Loading...
