Item Specification Comments
Path failover HDLM
1
Supports Microsoft MPIO (Multi
P
ath I/O)
Link 10 Gbps SFP+ N/A
Transfer speed 10 Gbps N/A
Connector type LC N/A
Cable Optical OM3, OM2 MMF cable N/A
Network switch L2 or L3 switch Should comply with
IEEE802.3ae
Switch cascading Maximum: 5 switches or fewer Minimum number of cascading
switches is recommended.
MAC address Per port (fixed value) Factory setting: World Wide
Unique value. Cannot be
changed.
Maximum transfer unit (MTU) 1,500, 4,500, 9,000 bytes
(Ethernet frame)
Jumbo frame, MTU size greater
than 1500
Link aggregation Not supported N/A
Tagged VLAN Supported N/A
IPv4 Supported N/A
IPv6 Supported
Note the following precautions:
• When iSCSI Port IPv6 is set
to Enabled, if the IPv6
global address is set to
automatic, the address is
determined by acquiring a
prefix from an IPv6 router.
• If the IPv6 router does not
exist in the network, the
address cannot be
determined. As a result, an
iSCSI connection might be
delayed. When an iSCSI
Port IPv6 is set to Enabled,
verify the IPv6 router is
connected to the same
network, and then set IPv6
global address
automatically.
Subnet mask Supported N/A
Gateway address Supported N/A
DHCP N/A N/A
DNS N/A N/A
Ping (ICMP ECHO) Transmit,
R
eceive
Supported N/A
Storage system specifications 115
Hitachi Virtual Storage Platform G400, G600 Hardware Reference Guide
To Next Page
Loading...
