Hitachi Advanced Server HA820 G2 User Guide 134
1.
Power down the server.
2.
Do one of the following:
•
Disconnect each power cord from the power source.
•
Disconnect each power cord from the server.
3.
Do one of the following:
•
Extend the server from the rack.
•
Remove the server from the rack.
4.
Remove the access panel.
5.
Remove the serial port blank.
6.
Install the serial port interface.
7.
Connect the cable to the system board.
8.
Install the access panel.
9.
Install the server in the rack.
10.
Connect each power cord to the server.
11.
Connect each power cord to the power source.
To Next Page
Loading...
