Hitachi Advanced Server HA820 G2 User Guide 65
8.
Insert the return wire into the right side of the connector, and then tighten the screw to 1.3 N m (10
lb-in) of torque.
9.
Install the terminal block connector into the power supply.
10.
Secure the power cord, wires, and/or cables in the strain relief strap attached to the power supply
handle:
a. Unwrap the strain relief strap from the power supply handle.
CAUTION:
Avoid tight bend radii to prevent damaging the internal wires of a power cord or a server cable. Never
bend power cords and server cables tight enough to cause a crease in the sheathing.
b. Secure the power cord, wires, and cables with the strain relief strap. Roll the extra length of the strap
around the power supply handle.
To Next Page
Loading...
