raidcom modify ldev -status nml
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
Get Command
Status
Async 2E10 0008 The specified LDEV is used as a system disk.
CMDRJE Executing 2E10 0010 LDEV is not blocked.
Get Command
Status
Async 2E10 0012 The specified LDEV is a CC/XRC attribute device.
Get Command
Status
Async 2E10 001E The specified LDEV is not formatted after it is used
as the journal volume.
Get Command
Status
Async 2E10 0062 The specified LDEV is used as the primary volume
of a GAD pair.
Get Command
Status
Async 2E10 0063 The specified LDEV is used as the secondary
volume of a GAD pair.
Get Command
Status
Async 2E10 600B The pool is blocked.
Get Command
Status
Async 2E11 0009 The operation cannot be performed because LDEV
is not expanding.
Get Command
Status
Async 2E11 001E The operation cannot be performed because the
virtual disk space is blocked.
CMDRJE Executing 2E11 0053 The specified LDEV is used in another operation.
CMDRJE Executing 2E11 0153 The parity group or the external group to which the
specified LDEV belongs is used in another
operation.
Get Command
Status
Async 2E11 6006 The operation of Dynamic Provisioning V-VOL
cannot be performed because there is a blocked
pool volume.
Get Command
Status
Async 2E11 8004 The operation cannot be performed because the
internal processing is in progress.
CMDRJE Executing 2E11 9400 The command cannot be accepted. After a while,
execute the same command.
CMDRJE Executing 2E20 0000 The specified LDEV is not installed.
Get Command
Status
Async 2E30 000A The specified LDEV is used for a Dynamic
Provisioning.
Get Command
Status
Async 2E30 000C The specified LDEV is used as a quorum disk.
Get Command
Status
Async 2E30 000E The specified LDEV is used as a pool volume.
Get Command
Status
Async 2E30 0014 The specified LDEV is used as a reserved volume of
Volume Migration.
Get Command
Status
Async 2E30 001A Volume Security is set to the specified LDEV.
Troubleshooting
9-59
Command Control Interface User and Reference Guide
To Next Page
Loading...
