raidcom modify ldev -status nml
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
Get Command
Status
Async 2E30 002C The specified LDEV cannot be restored because the
shredding or the formatting operation has not been
performed.
Get Command
Status
Async 2E30 004E The specified LDEV is a Data Retention Utility/
Volume Retention Manager attribute device.
Get Command
Status
Async 2E31 0017 LDEV cannot be restored because there is no
connection path to the normal external path.
CMDRJE Executing 2EE8 00EE The command cannot be accepted. After a while,
execute the same command.
Table 9-33 SSB codes returned by raidcom modify ldev -status blk
raidcom modify ldev -status blk
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E00 0000 The LDEV number is out of settable range.
Get Command
Status
Async 2E10 0000 The specified LDEV is used for a pair of
ShadowImage/Thin Image/Copy-on-Write
Snapshot/Volume Migration or as a relationship of
Compatible FlashCopy® V2/Compatible Software
for IBM® FlashCopy® SE.
Get Command
Status
Async 2E10 0001 The specified LDEV is used for a pair of TrueCopy
or Universal Replicator.
Get Command
Status
Async 2E10 0003 The specified LDEV is used as a Compatible
FlashCopy® V2 relationship.
Get Command
Status
Async 2E10 0004 The specified LDEV is used for a Thin Image pair or
a Copy-on-Write Snapshot pair.
Get Command
Status
Async 2E10 0008 The specified LDEV is used as a system disk.
CMDRJE Executing 2E10 0011 LDEV is not installed, or LDEV is not in the state of
Normal.
Get Command
Status
Async 2E10 0012 The specified LDEV is used at the concurrent copy
or XRC.
Get Command
Status
Async 2E10 0062 The specified LDEV is used as the primary volume
of a GAD pair.
Get Command
Status
Async 2E10 0063 The specified LDEV is used as the secondary
volume of a GAD pair.
Get Command
Status
Async 2E11 0009 The operation cannot be performed because LDEV
is now expanding.
9-60
Troubleshooting
Command Control Interface User and Reference Guide
To Next Page
Loading...
