raidcom disconnect path
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE
CMDRJE Executing 2E20 4400 WWN is not registered.
CMDRJE Executing 2E20 4500 This command cannot be operated due to one of
the following reasons:
• There is no path group.
• external_wwn is not defined.
CMDRJE Executing 2E20 8401 The specified virtual port is not defined.
Get Command
Status
Async 2E30 001E Online from the mainframe host.
CMDRJE Executing 2E30 8400 The attribute of a port is not External(ELUN).
CMDRJE Executing 2E30 840E The command cannot be executed with the
specified port attribute.
CMDRJE Executing 2EDA 00EE The command cannot be accepted. After a while,
execute the same command.
Get Command
Status
Async 2EDA 0905 An internal error occurred by the operation of a
path for an external path.
Call Hitachi Data Systems customer support.
CMDRJE Executing B980 B901 The command was rejected because the specified
port is for NAS platform (System LU).
CMDRJE Executing B980 B902 The command was rejected because the specified
port is for NAS platform (User LU).
Table 9-101 SSB codes returned by raidcom delete path
raidcom delete path
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E00 4500 The path group is not in a effective range.
CMDRJE Executing 2E00 8400 The value of the specified port is incorrect.
CMDRJE Executing 2E02 8403 The specified virtual port number is out of range.
Get Command
Status
Async 2E10 4303 The path operations cannot be performed for the
following reasons:
• The target of the specified path group is
TagmaStore USP/TagmaStore NSC.
• The specified path group contains an external
volume for which the reserve attribute is set
by the host.
CMDRJE Executing 2E10 8404 The iSCSI virtual port mode for the specified port
is disabled.
Troubleshooting
9-151
Command Control Interface User and Reference Guide
To Next Page
Loading...
