raidcom add path
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
Get Command
Status
Async 2E10 4303 The path operations cannot be performed for the
following reasons:
• The target of the specified path group is
TagmaStore USP/TagmaStore NSC.
• The specified path group contains the external
volume that is set the reserve attribute from
the host.
Get Command
Status
Async 2E10 4400 The WWN on the side of the specified external
storage is not connected to an External port.
This message may be output if the migration
source storage system is USP V/VM and the host
mode option 2 is not set to the port that connects
to the migration target storage system.
CMDRJE Executing 2E10 8404 The iSCSI virtual port mode for the specified port is
disabled.
Get Command
Status
Async 2E11 410E An external volume that is the mainframe
emulation type is included in the specified external
path group.
Get Command
Status
Async 2E11 8011 The operation cannot continue because the
microcode is being replaced.
CMDRJE Executing 2E11 9400 The command cannot be accepted. After a while,
execute the same command.
CMDRJE Executing 2E20 4100 There is no external volume group.
Get Command
Status
Async 2E20 4400 Invalid WWN.
CMDRJE
Get Command
Status
Executing
/Async
2E20 4500 There is no path group.
CMDRJE Executing 2E20 8401 The specified virtual port is not defined.
CMDRJE
Get Command
Status
Executing/
Async
2E22 4300 The same path has been defined already.
Get Command
Status
Async 2E23 4303 The operation cannot be performed because the
number of path in the path group exceeds 8.
CMDRJE Executing 2E30 8400 The attribute of a port is not External (ELUN).
CMDRJE Executing 2E30 840E The command cannot be executed with the
specified port attribute.
Get Command
Status
Async 2E31 4000 The specified external storage LU is the device of
not supported.
Get Command
Status
Async 2E31 4001 The specified external storage system is not
supported.
Troubleshooting
9-153
Command Control Interface User and Reference Guide
To Next Page
Loading...
